Xmotorstore Payments
Front wheel pin 10x160 for hub (L) L.94 Grc
Reference: 2012 A
Brand: STAMAS
Pair of Stamas factory mini fork tubes diameter 25 mm in aluminum. Gold colored aluminum.
Reference: 1025
Brand: STAMAS
Stamas midi rear swingarm standard model 1025
Reference: 143.395.015
Brand: POLINI
Polini minibike front brake wire, for mechanical brakes. Polini code: 143.395.015
Reference: GHR 015.001
Brand: GHR
Cylinder Ghr 9 pcs reinforced duty kit
Reference: F00 006
Brand: DM
Pair of rear wheel bearings with 114 mm spacer (HYDRAULIC BRAKES)
Reference: 143.340.001
Brand: POLINI
Polini minibike high voltage coil support bracket. Polini Code: 143.340.001
Reference: 017010
Brand: BZM
Bzm minimoto piston for 50cc 2t. Original Bzm piston diameter 40mm with flat head for 50cc 2t engines. Available in sizes: Piston bzm selection 0. Piston bzm selection A. Bzm piston AA selection. Piston bzm selection B. Attention: The clearance between piston and cylinder must be approximately 0.040 (four hundredths).
Reference: FM-L011-05
Brand: Formula
Formula brake lever for minibikes and pitbikes. Right and left brake lever, universal. Formula Code: FM-L011-05
Reference: 143.265.001
Brand: POLINI
Polini minibike starter rope roller return spring. Polini Code: 143.265.001
Reference: 7004
Brand: STAMAS
Stamas minimoto internal steering head spacer
Reference: 143.025.006
Brand: POLINI
Polini chromed 36x1 mm segment for 40cc minimoto engines. Polini Code: 143.025.006 The 36x1 chromed minibike segment allows better performance while maintaining reliability and durability.
Reference: 005002
Brand: BZM
Clutch plate pins with M7 thread (2pcs) - 2-mass clutch 005002
Reference: 001002R08000
Brand: DM
hardware kit for frame and minimoto fairings Dm
Reference: 143.246.001
Brand: POLINI
Rubber cap for Polini 910 minimoto tank cover. Polini code: 143.246.001
Reference: 076
Brand: DM
Handlebar vibration dampers Dm red. The Dm mini bike rockers are used to stabilize and protect the handlebar from impacts.
Reference: 001002R002B0
Brand: DM
Conical spacer on the crown side DM, the spacer must be inserted between the swingarm and the wheel bearing with the diameter of the narrowest cone towards the bearing. The wheel spacer Dm has the following measures: Hole diameter 10 mm Outside diameter 24 mm Outside diameter narrow part 15 mm Spacer thickness 10 mm Dm code: 001002R002B0
Front wheel pin 10x160 for hub (L) L.94 Grc
