Xmotorstore Payments
With the ZECA EV cable reels with wallbox it is possible to recharge electric vehicles with minimal effort, keeping the garage tidy and protecting the cables from wear.
Available with Type 1 and Type 2 connectors
The Type 1 connector is the North American and Japanese standard, but is very widespread on vehicles (it is not usually installed on charging stations). This connector can only be used for single-phase charging.
The Type 2 connector is the European standard for AC charging stations and is the most used connector on electric cars by European electric vehicle manufacturers. This connector can be used for both single-phase and three-phase charging.
Wi-Fi available for EV2161WB+ and EV2162WB+ models
CAUTION When installing the product, remember to connect the thermal protection according to one of the two diagrams inside the package.
With the ZECA EV cable reels with wallbox it is possible to recharge electric vehicles with minimal effort, keeping the garage tidy and protecting the cables from wear.
Available with Type 1 and Type 2 connectors
The Type 1 connector is the North American and Japanese standard, but is very widespread on vehicles (it is not usually installed on charging stations). This connector can only be used for single-phase charging.
The Type 2 connector is the European standard for AC charging stations and is the most used connector on electric cars by European electric vehicle manufacturers. This connector can be used for both single-phase and three-phase charging.
Wi-Fi available for EV2161WB+ and EV2162WB+ models
CAUTION When installing the product, remember to connect the thermal protection according to one of the two diagrams inside the package.
Reference: 01.SW.0120.L
Brand: Ohvale
Ohvale Plug of thightener Code: 01.SW.0120.L
Reference: 01.MO.0451.L
Brand: Ohvale
Ohvale Cylinder 212 Code: 01.MO.0451.L
Reference: 318556
Brand: Malossi
Malossi thermal unit diameter 40 mm in cast iron 318556 Code: 318556 Malossi cylinder kit in cast iron diameter 40 mm with pin diameter 10 mm for h2o engine Malossi cast iron thermal units, the first and simplest step to modify the engine of your moped, are the best choice to continue using a standard or approved exhaust system. In these thermal groups...
Reference: 206.0289
Brand: POLINI
Polini segment dimensions 40.8x1.26 mm trapezoidal chromed Universal Polini segment
Reference: 5519425B
Brand: Malossi
Malossi Injtronic 5519425B electronic control unit Code: 5519425B Malossi Injtronic electronic control unit for original cylinder. The Injtronic engine control unit is the natural evolution of the original Piaggio system and allows the vehicle's performance to be increased. The use of a latest generation 32-bit microprocessor, in synergy with hardware...
Reference: FRZ.HM3
Brand: CS Racing
Clutch Cs minimoto HAMMER EPIC. Clutch for minimoto compatible with Cs, Iame, Ghr, Bzm engines. This clutch must be used with an 81mm bell. Cs clutch models: - HAMMER GT Low friction coefficient, allows greater slip without affecting performance - HAMMER GP Medium-high friction coefficient - HAMMER EPIC High Coefficient
Reference: 210.0035
Brand: POLINI
VESPA: VESPA 125 2T PRIMAVERA - VESPA 125 2T PRIMAVERA ET3
Reference: A2203
Brand: Alfano
Alfano speed sensor 195 cm. Code A2203. New model (10-03-2019), this speed sensor can be installed directly on the Alfano 6 and on the PROIIIevo (in the green connector), without the need to use the A2192 (old model) or A2194 Hub. This sensor can be used on the rear axle or the front wheel of the kart. Note: For those who need an extension cable to...
Reference: 104100
Brand: Motul
Motul 7100 4T 10W-60 104100 oil. For high performance 4-stroke engines of sports bikes, road, trial, off-road, enduro, etc., with or without integrated gearboxes and wet and non-wet clutches. For engines compliant with the regulations relating to the regulation of polluting emissions, Euro 2, 3, 4 or 5 and equipped with exhaust gas post-treatment systems:...
Reference: 272.0134
Brand: POLINI
Polini pin stop diameter 10x1 mm square wire
Reference: 03.CA.0004.G
Brand: Ohvale
Ohvale Cover tank fairing unpainted Code: 03.CA.0004.G
Reference: 246.032
Brand: POLINI
Twin cooling of the transmission group with the “Air Speed Drive” developed by Polini. By using the AIR SPEED DRIVE you improve decisively the aeration inside the crankcase and consequently it increases both the engine performance for long distances covered and the belt life. The Polini SPEED DRIVE and CERAMIC SPEED DRIVE for Piaggio and Yamaha include...
Reference: 209.0465
Brand: POLINI
Polini gasket set diameter 52 mm 209.0465 Code: 209.0465 Polini gasket set diameter 52 mm for Yamaha horizontal h2o Polini gaskets set for: Aprilia, Aprilia Aera 51, Aprilia Rally 50, Aprilia Sonic 50, Aprilia Sr 50, Benelli, Benelli 491 50, Benelli K2 50, Beta, Beta Ark 50, Beta Eikon 50, Italjet, Italjet Dragster 50, Malaguti , Malaguti F 12 50,...
Reference: MLL.0041
Brand: CS Racing
Blue clutch springs for minimoto, wire 2, 3mm (JUNIOR). The blue springs replace the previous purple version, they are recommended on junior engines.
Reference: 133.1003
Brand: POLINI
Polini thermal group kit diameter 47 mm h2o. Polini Code: 133.1003. Polini cylinder kit for: Benelli, Benelli Devil 50, Benelli Spring 50, Malaguti, Malaguti Mrx 50, Minarelli, Minarelli DL3. Cast iron cylinder
With the ZECA EV cable reels with wallbox it is possible to recharge electric vehicles with minimal effort, keeping the garage tidy and protecting the cables from wear.
Available with Type 1 and Type 2 connectors
The Type 1 connector is the North American and Japanese standard, but is very widespread on vehicles (it is not usually installed on charging stations). This connector can only be used for single-phase charging.
The Type 2 connector is the European standard for AC charging stations and is the most used connector on electric cars by European electric vehicle manufacturers. This connector can be used for both single-phase and three-phase charging.
Wi-Fi available for EV2161WB+ and EV2162WB+ models
CAUTION When installing the product, remember to connect the thermal protection according to one of the two diagrams inside the package.
